Automotive Manual PDF

RSS Feed

The Resources for Automotive

2003-2005 Power Commander Ducati M800 S2R Installation Instructions

February 7th, 2009 · No Comments

1. Remove the seat
2. Lift the front of the fuel tank up.
3. Remove the left hand side cover (Fig. A). The PCIII will be mounted behind this cover later on.
4. Route the ground wire from the PCIII behind the frame rail (Fig. B).
5 Remove the lower mounting bolt for the ignition coil (Fig. C). The ignition coil is located on the left hand side of the bike behind the pass-neger footrest bracket.
6 Attach the ground wire from the PCIII through this bolt and retighten bolt
7 Route the PCIII behind the frame tube as in Fig. D. and route along the left hand frame tube going towards the air box.
8. Locate the Throttle Position Sensor (TPS). This sensor is located on the L.H side of the bike, between the frame and the throttle body.
9. Unplug the harness from the sensor and pull the connector towards the outside of the frame to access the wires (Fig. E).

Get pdf 2003-2005 Power Commander Ducati M800 S2R Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , ,


Related Keyword: reset maintenance ducati m800

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.