Automotive Manual PDF

RSS Feed

The Resources for Automotive

K9 Security and Remote Start System Installation Manual

April 24th, 2009 · No Comments

This system is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
• This product must be installed by qualified personnel according to these instructions and and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area. Do not use in a closed garage or indoors

Before you begin the installation:
• Verify that the vehicle is equipped with electronic fuel injection.
• Verify that the vehicle is equipped with an automatic transmission.
• Verify that the vehicle starts and idles properly before you start the installation.
• Always use a multi-meter when verifying vehicle wiring.
Remote Start Installation Notes:
The system senses the vehicle’s successful start using one of the following methods:
1. Current sense
2. Tachometer sense
3. Spark or Coil Wire sense

If the Current Sense feature of the system does not allow proper operation, the tachometer sense/spark sense wire may be used, or an optional vacuum switch can be installed.

To use the tach sense/spark sense wire, set dip switch #4 to the off position. Connect the gray wire directly to the vehicle’s tach wire or extend it into the engine compartment and wrap it several times around a spark plug or coil wire.

In situations were a tach wire is unavailable or does not allow proper operation, an optional vacuum switch can be installed. The vacuum switch is designed to be placed in line with one of the vehicle’s vacuum hoses and provide a ground output (N/C) until the engine is started. To use the vacuum switch, set dip switch #2 to the off position. Connect the yellow wire (3-pin red connector) to one terminal of the vacuum switch and connect the other terminal to ground.

Get pdf K9 Security and Remote Start System Installation Manual

Related Entries


Related Tags: , , , , , , , , , , , , , , , , ,


Related Keyword: K9 Classic Alarm Manual, K9 Car Alarm Manual, system k-9 classicE anti-theft-car alarm, k9 classic car alarm systems, k-9 classic car alarm manual

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.