Automotive Manual PDF

RSS Feed

The Resources for Automotive

99-05 Chevy/GMC PU/SUV 4.8, 5.3, 6.0L Airaid Modular Intake Tube Installation Instructions

October 22nd, 2009 · No Comments

Installation Instructions. Read Me!
I. DISCONNECT NEGATIVE (-) BATTERY CABLE
II. Remove Factory Intake Assembly
a) Loosen the factory hose clamps on each end of the factory intake tube assembly.
b) Using a flat head screwdriver, gently pry the radiator hose bracket from the factory intake tube assembly and remove from vehicle.
III. Airaid Modular Intake Tube Installation
a) Install the GM coupler provided, onto the Airaid Modular Intake Tube (MIT).
b) Install the silicone hump hose provided onto the Airaid Modular Intake Tube (MIT) with the supplied hose clamps. (Hint: slide the hump hose all the way onto the end of the MIT.
c) Install the Airaid MIT in place of the factory intake tube assembly.
d) Check for interference and adjust the MIT accordingly, then tighten the hose clamps.
IV. Airaid Jr. P/N 200-712 Replacement Filter
a) If you purchased the Airaid Jr. kit P/N 200-712, replace the factory air filter with the Airaid Premium Filter included in the Airaid Jr. kit.
V. Finishing Up
a) Make sure that the intake path is clear of debris.
b) Double check work to ensure proper fit and that all clamps are securely fastened.
c) Re-connect negative battery cable.
Note: Provisions have been made to mount the factory filter minder onto the MIT when used in conjunction with the Airaid Cool Air Dam . A 17mm hole must be drilled on the back side of the tube. A circular impression on the rear of the tube indicates the correct hole location. Use the factory grommet to mount the filter minder.

Get pdf 99-05 Chevy/GMC PU/SUV 4.8, 5.3, 6.0L Airaid Modular Intake Tube Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: 05 gmc 2500 manifold inlet tube

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.