Automotive Manual PDF

RSS Feed

The Resources for Automotive

2003-2004 Honda Accord 4-Cyl. 2.4L Short Ram Intake System Installation

October 28th, 2009 · No Comments

Removal of the Stock Air Intake System
a) Loosen the clamp around the throttle body using a 5.5mm socket or screwdriver. Pull the Intake Air Temperature (IAT) sensor out of the intake tube by loosening the spring loaded clamp.
b) Unplug the breather tube from the fitting underneath the intake manifold.
c) Remove the air box mounting bolt shown in the picture.
d) Remove the other air box mounting shown in the picture.
e) Carefully remove the air box assembly from the engine bay.
f) Remove the two fasteners holding the plastic cover in front of the battery.
g) Pull upward on the plastic cover to remove the resonator box intake tube.
h) From inside the driver-side wheel well, remove the fastener shown in the picture.
i) From underneath the vehicle, remove the fasteners shown in the picture.
j) Tuck the splash guard out of the way behind the brake rotor.
k) Remove the resonator mounting bolt shown in the picture.
l) Remove the screw holding the corner of the front bumper cover.
i) From underneath the vehicle, remove the fasteners shown in the picture.
m) Unsnap the corner of the bumper cover as shown in the picture. This will help in removal of the resonator assembly.

Get pdf 2003-2004 Honda Accord 4-Cyl. 2.4L Short Ram Intake System Installation

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: disarm car alarm on honda accord, 2002 zetec intake removal, disconnect a 2004 honda accord alarm, how to fix resonator box on 2003 honda accord 4 cyl, 2003 honda crv intake manifold removal

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.