Automotive Manual PDF

RSS Feed

The Resources for Automotive

2004-05 Honda Civic L4-1.6L Typhoon Cold Air Intake System Installation Instructions

November 5th, 2009 · No Comments

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection as shown.
3. Unclip the battery cable from the air inlet duct as shown.
4. Loosen and remove the two bolts that secure the air inlet duct as shown.
5. Remove the air inlet duct.
6. Loosen and remove the four bolts that secure the air intake resonator.
7. Loosen and remove the two bolts that secure the throttle body plenum.
8. Loosen the hose clamp that secures the plenum to the throttle body as shown.
9. Using a pair of pliers, depress and pull back the hose clamp on the crank case vent at the cam cover.
10. Pull firmly upwards to remove the throttle body plenum as shown.
11. Using a flat blade screwdriver, unclip the wire harness from the resonator as shown.
12. Unclip the throttle cable and cruise control cable (If equipped), then, remove the resonator by pulling upwards as shown.
13. Secure the throttle cable and cruise control cable (if equipped) to the stock clips as shown.

Get pdf 2004-05 Honda Civic L4-1.6L Typhoon Cold Air Intake System Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: algo-charter_if, TJCs Plenum Removal Guide for V6 8G Galants & 3G Eclipses, removeairplenumfrom2006chrysler3003 5, 13156575466@ah165 net, 2005 galant plenum removal

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.