Automotive Manual PDF

RSS Feed

The Resources for Automotive

Honda/Suzuki Electronic Jet Kit Instructions

November 9th, 2009 · No Comments

This product is a great fit for stock bikes with exhaust and intake mods. It is also capable of handling the fuel needs of big bore kits, light cams, and a variety of head porting. This is an Electronic Jet Kit. Like jet kits in the past, the more you modify, the more responsibility you take in getting your fuel curve right. Going to www.dobeckperformance.com will help you obtain better high horsepower tuning.

INSTALLATION
(at any time during install or tuning please call us for any and all help, we can’t help if you don’t call)
1. Before installing the TFI you must first disconnect the negative lead from the battery.
2. Determine a location for the TFI unit. Suggested locations are as follows: Under the seat, behind a side cover or tail section.
3. The TFI comes with a harness with injector connectors that match the factory injector connectors.
4. Locate the factory fuel injectors (see owners manual if you are not sure).**
**: Some models are equipped with two sets of injectors (primary and secondary) the unit is designed to interface with the primary injectors. If the TFI harness does not match your injectors do not proceed and call tech support at 877-764-3337.
5. Disconnect the factory injector connectors from the fuel injectors and replace with the TFI injector connectors from the TFI unit, basically unhook the factory injector connector and plug the matching TFI connector (female) to the injector and then connect the factory injector connector to the TFI connector that simulates the injector (male). There is no order to hook up the TFI harness to the factory harness just make sure the original factory connector goes to its’ original cylinder. It is a good idea to make sure there is a little slack in the harness to prevent engine vibration from damaging/breaking a wire on the connectors.
6. Be sure to check the wires are not in direct contact with any sharp edges, exhaust and/or other objects, which could result in long term wear and/or damage.
7. Connect the TFI ground lead to the negative terminal of the battery along with the factory ground lead.
8. With the rubber plug removed from the TFI, turn the motorcycle key switch to the “ON” position. As the bikes electrical system goes through initial start up mode you may see LED’s flashing on the TFI.

Get pdf Honda/Suzuki Electronic Jet Kit Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , ,


Related Keyword: honda yhnxs 3892ak

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.