Automotive Manual PDF

RSS Feed

The Resources for Automotive

2006-2007 Honda Civic DX/LX/EX 1.8L Cold Air System Installation Instructions

November 10th, 2009 · No Comments

Removing the stock air inlet system
a) Pry loose the retaining buttons on the lower splash shield.
b) Remove all retaining buttons on the fender liner around the fender well.
c) Carefully pull back the fender liner and splash shield to gain access to the fender well and stock resonator box.
d) Remove the battery from the engine bay.
e) Remove the plastic battery tray.
f) Remove the two bolts that secure the intake arm to the battery tray.
g) Slide the rubber part of the intake arm off of the airbox inlet. Remove the intake arm from the engine bay.
h) Disconnect the MAF sensor harness. Remove the harness clip from the airbox and move the harness out of the way.
i) Push back all the clips holding the filter lid, and remove the lid and the air filter from the vehicle.
j) Separate the lines from the rubber coupler. Loosen the hose clamp at the throttle body end of the rubber coupler.
k) Pull the metal breather line out of the rubber grommet on the airbox.
l) Pull the metal breather line out of the rubber hose attached to the valve cover. Then pull the rubber hose off the valve cover.
m) Remove the two bolts that secure the airbox. Carefully remove the airbox with rubber coupler out of the engine bay.
n) Remove the bolt holding the resonator box on the side of the fender well.

Get pdf 2006-2007 Honda Civic DX/LX/EX 1.8L Cold Air System Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , ,


Related Keyword: honda civic code b13, honda civic b13 code, honda civic service code b13, 2007 honda civic service code b13, honda civic b13 service codes

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.