Automotive Manual PDF

RSS Feed

The Resources for Automotive

2002-2005 Honda Civic Si Cold Air System Installation Instructions

November 12th, 2009 · No Comments

Our system is constructed of lightweight aluminum and then painted with a zirconia based powder coat for superior heat insulating characteristics. The aluminum will not crack in extended use like plastic and it is actually lighter than plastic. The tube diameter and length are matched for each engine to give power over a broad rpm range. Unlike the plastic systems that use a continually diverging cross section, we take advantage of the acoustical energy in the duct to promote cylinder filling during the intake valve-opening event.

Our Dyno testing as well as independent dyno tests (see 7/97 Sport Compact Car Magazine) prove that the AEM Cold Air System produces as much as twice the power gain than any other system on the market.

Installation of the AEM Cold Air Intake System.
a) When installing the Cold Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Install the included rubber mount in the factory threaded hole in the frame, as shown.
c) Install the supplied rubber mount and the factory IAT sensor in the Cold Air Pipe.

Get pdf 2002-2005 Honda Civic Si Cold Air System Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.