Automotive Manual PDF

RSS Feed

The Resources for Automotive

2003-2005 Hyundai Tiburon V6 Short Ram System Instructions

March 24th, 2010 · No Comments

Removal of the stock intake system.
a. Remove the upper plastic cover covering the stock intake system.
b. Remove the hose clamp securing the upper filter box to the air flow sensor. Unlatch the two clips securing the upper filter box and remove.
c. Remove the filter. Remove the three bolts securing the lower filter box and remove from vehicle.
d. Kit removed from vehicle.

Installation of the AEM Cold Air Intake System.
a) When installing the Cold Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b. Install the filter over the air flow sensor and secure using the supplied hose clamp.
c. Remove the bolt securing the vibration dampener. Install the bracket securing it with the supplied bolt.
d. Remove the wire harness clip from the hose clamp. Install the bracket with the supplied bolt, washer and nut.
e. Install the wire harness clip into the second hole on the mounting bracket.
f. Kit installed on vehicle.

Re-assemble the vehicle
a) Position the filter for best fitment. Be sure that the filter or any other components do not contact any part of the vehicle.
b) Tighten all hose clamps.
c) Tighten the bolts and nuts on the mounting bracket.
d) Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are tight.
e) Start engine and perform a final inspection before driving the vehicle.

Get pdf 2003-2005 Hyundai Tiburon V6 Short Ram System Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: Hyundai Tiburon Clutch Replacement Instructions

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.