Automotive Manual PDF

Attach sticker on drivers-side door beam (B-pillar); the sticker is found as an instruction contained in the very front of the owner information packet. Cross out the instruction after attaching the sticker. Attach sticker “Your next service event” : - Service sticker “Your next service event” : Mark Oil change service or Inspection service (whichever is the case next) with a cross and enter date / mile / kilometer reading; if necessary, also mark with a cross additional work to be performed (e.g. replace toothed belt) and brake fluid service and enter date / mile / kilometer reading service interval 01-4

Inspection Service - Attach sticker Work descriptions on drivers side door beam - B - pillar Battery, check battery terminals for secure seating Special tools, testers and auxiliary items required Torque wrench V.A.G 1331 (5 - 50 Nm) Note: Tight fitting battery terminals guarantee proper function and a long battery service life. - Open cover cap (if installed) - 1 - of battery positive pole. - Check battery terminal clamps are seated securely on the battery terminals by moving the battery positive wire 1 - and the battery Ground (GND) wire - 2 - back and forth by hand. Warning! If battery clamp is not seated securely on positive terminal, disconnect battery Ground (GND) strap on battery negative terminal first, to prevent possible accidents. Work descriptions If the battery clamp on positive terminal is not seated securely: - Disconnect battery Ground (GND) wire at battery negative terminal first - 2 - . - Tighten battery clamp on battery positive terminal to 5 Nm. - Close cover cap on battery positive pole. - Re-connect battery Ground (GND) wire to battery negative pole - 2 - and also tighten to 5 Nm. If the battery clamp on negative terminal is not seated securely: - Tighten battery clamp - 2 - on battery negative terminal to 5 Nm. Battery, checking - Delivery Inspection: Perform visual check. Repair Manual, Electrical Equipment, Repair Group 27, Checking battery: visual check, electrolyte level, no load voltage, load test. - Inspection Service: Perform visual check and electrolyte level check. Repair Manual, Electrical Equipment, Repair Group 27, Checking battery: visual check, electrolyte level, no load voltage, load test. Wheel securing bolts, tighten to correct torque setting Work descriptions Special tools, testers and auxiliary items required Torque wrench V.A.G 1332 (40 -200 Nm) Note: Make sure that wheel bolts are tightened alternately to the following tightening torque: 4-hole wheel mounting Tightening torque: 110 Nm 5-hole wheel mounting Tightening torque: 120 Nm Clock, setting Digital clock: Two press buttons - 1 - are located below the tachometer at right for setting the clock. The hour is set using the upper button - h - , the minute is set with the lower (min). - By pressing briefly, best done using a ball point pen, the time is set ahead by one hour or minute respectively. Work descriptions Sustained pressing advances the hours/minutes through the whole sequence. The clock can be set accurately to the second using the minute button. - Press button until the clock displays one minute less than the time to be set. Press the button at the instant when the second display of an accurate clock has reached a full minute or the time signal sounds from the radio.

Get pdf Volkswagen Golf III Maintenance Manual Guide