Install plastic brake cable guide (7) in rear of middle body mount. Install new parking brake cable guide (24) in existing frame hole as shown. Remove forward most brake cable guide and replace with new guide (6). Install driver side front linkage in first sheetmetal tab / hole from front. Install threaded clamping plate (13) on top of pinch weld and thread fastener ( 10) into clamping plate and torque to 16 ft-lbs. (22 N m). Next install fastener (12), finger tighten only.
Install driver side rear motor linkage in fourth sheetmetal tab / hole from front (Crew Cab). Linkage will then clear parking brake cable. Slide mounting T-nut into position, aligning the end of the board with the rear edge of the back door. Mount board and tighten fasteners to 10 ft-lbs. Insure linkages are squared to body prior to torquing fasteners.
Get pdf Chevrolet Silverado / GMC Sierra - Crew Cab 2007
0 comments for this entry ↓
There are no comments yet for this entry.
Leave a Comment