Automotive Manual PDF

Installing rivet nuts
1) Assemble rivet nut install tool as shown in figure 1
2) Place assembly into hole in frame so that the rivet nut sits flush to frame
3) Use wrench to hold rivet nut install tool and tighten bolt (see fig.2)
4) Make sure rivet nut stays flush while tightening bolt.
5) Tighten bolt to 30 ft-lbs (41N-m)

Note:Steps 1-8 shown on drivers side. Repeat these steps on passengers side

Make sure rivet nuts sit flush when completely installed
Install linkage assemblies using M8 x 35 bolts and M8 washers. Do not torque bolts, finger tighten only
Install brackets to driving assembly and top mounting bolt on rear bracket.
NOTE: Right and left driving assemblies. FRONT bracket attaches to gear assembly side.

Get pdf Jeep Wrangler (TJ) 2003–2006 AMP Installation Guide