The lighting kit requires that you have the newer Power Step control module. If you don’t have the correct module, the correct part number is listed on the previous page. Remove Power Step harness from control module, cut cable tie and remove plug of center pin slot. Insert metal terminal of the Lighting Kit harness into center pin slot of connector. Make sure the terminal fully engages.
Attach supplied black Posi-Tap® to the black wire of Power Step harness. Make sure that the Posi-Tap® threads on straight. Attach black wire of lighting kit harness to Posi-Tap®. Route Lighting kit harness along Power Step harness, securing with cable ties, and back toward rear linkage assembly of each Power Step. Only loosely secure harness along sill. For vehicles with vertical pinch weld, drill 9/32” hole through pinch weld at desired lamp locations. Insert grommet and lamp wires through drilled hole.
Get pdf PowerStep Lighting Kit Installation Guide
0 comments for this entry ↓
There are no comments yet for this entry.
Leave a Comment