To ensure our customers receive all components with full integrity, we pack the motors separate from their linkage assemblies. This requires that the installer position and fasten the motor before continuing with the install. Please follow the instructions below and handle the assembly carefully.
CAUTION: Dropping the assembly or any excessive impact MAY cause damage to the motor.
Instructions:
1. Position the gear cover in place as shown if not already in place.
2. Seat motor into position on the three mounting bosses. This may require an adjustment of the gear by moving the swing arms.
3. After seating into place, fasten the motor with the three motor mount screws with T30 Torx. Tighten screws to 80 in-lbs (9N-m). Do not over torque.
Use second and last set of mounting holes, counting from the front. Disengage parking brake. Pull parking brake cable rearward from forward support bracket to create slack in cable. Secure cable slack with locking pliers. Remove cable from rear support bracket and install cable bracket extension with large washer on front side of bracket. Re-install parking brake cable and remove locking pliers.
Get pdf Ford F-250 / F-350 / F-450 Regular Cab (48”) Installation Guide
0 comments for this entry ↓
There are no comments yet for this entry.
Leave a Comment