Automotive Manual PDF

RSS Feed

The Resources for Automotive

2003 Hummer H2 Component Locator Panel Identification

September 9th, 2008 · No Comments

Three-Dimensional Measurements
Three-dimensional measurements are provided in the absences of dimension information from your equipment supplier. Universal three-dimensional measuring equipment is required to use these numbers. You may need to adjust the height dimensions to match the datum height of your equipment. Only the width dimensions can be used to measure point-to-point. All holes, slots and fasteners are measured to the center.

Point to Point Measurements
Point-to-point measurements are for reference only. Use these measurements for diagnosis for validating. Point-to-point measurements do not afford the accuracy that 3–Dimensional measuring systems have. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths. All holes, slots and fasteners are measured to the center.

Get pdf 2003 Hummer H2 Component Locator Panel Identification

Related Entries


Related Tags: , , , , , , , , , , , , , ,


Related Keyword: removing driver side visor from Hummer h2, how to replace oil pressure switch in hummer h2, 2003 H2 SUN VISOR REMOVAL, hummer h2 fuel schematics, removal of radio on hummer h2

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.