Automotive Manual PDF

RSS Feed

The Resources for Automotive

Airaid Intake Systems 03-07 Hummer H2 200-146 Installation Guide

September 1st, 2008 · No Comments

1. Disconnect negative battery cable. Remove the factory filter minder and rubber grommet from the factory intake tube, retain for re-installation later in the install.
2. Loosen the recessed bolt and remove the beauty cover. Loosen the factory hose clamps on each end of the factory intake tube and remove it from vehicle.
3. Loosen the Mass Air Flow sensor hose clamp. Remove the MAF sensor from the factory air box and temporarily set it aside. Use caution to retain the factory coupler & hose clamp on the MAF
4. Remove the three factory air box hold down bolts, bushings, and grommets. Save them for the Airaid installation.
5. Remove the factory air box assembly from the engine compartment.
6. Align Cool Air Dam panels (#2, #3) & fasten together with saved grommets and bushings from step #4. Install the filter adapter (#4) using the 3 provided button head bolts (#10) and washers (#11).

Get pdf Airaid Intake Systems 03-07 Hummer H2 200-146 Installation Guide

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: 03 h2 schematic for transmission, 03 hummer h2 front differential breakdown

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.