Automotive Manual PDF

RSS Feed

The Resources for Automotive

2005-2006 Pontiac GTO High Flow Air Intake Installation Instructions

September 20th, 2008 · No Comments

Installation should take less than one hour with the proper tools. Before installation, set the parking brake and open the hood of the car. If car has been used recently, make sure engine has had time to cool before beginning to disassemble stock air intake. Please note that the hood was removed from the vehicle used for taking some of these pictures of the installation process. Some pictures show the hood supports disconnected from the hood. The hood does NOT need to be removed to install the LPE air intake and the hood support rods do NOT need to be removed either.

Step 1 – First remove the plastic radiator cover on the front of the engine compartment. To do so you will need to remove the five push lock style plastic fasteners that secure the cover to the vehicle. Use a screwdriver to pry the center nail of the push lock plastic fastener upward about half an inch
Step 2 – Then use the pry tool to fully remove the five panel pins and free the plastic panel from the body.
Step 3 – Loosen the metal hose clamp that attaches the air tube to the throttle body and remove the stock air tube from the throttle body.

CAUTION: Be very careful when handling the Mass Air Flow (MAF) sensor. Do not dent, puncture or otherwise damage the Honeycell located at the air inlet end of the MAF. Do not touch the sensing elements or allow anything (including cleaning solvents and lubricants) to come in contact with them. Do not drop or roughly handle the MAF.

Get pdf 2005-2006 Pontiac GTO High Flow Air Intake Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.