Automotive Manual PDF

RSS Feed

The Resources for Automotive

2005-2007 Chevrolet Corvette Lingenfelter High Flow Air Intake System Installation Instructions

September 23rd, 2008 · No Comments

The following steps need to be performed from underneath the vehicle:
• Remove the three 7 mm screws holding the front fascia inside the radiator opening.
• Next, remove the 7 mm screws on either side (one on each side). These are the screws holding the bottom of the bumper cover – see picture.

Remove the two plastic push lock plastic fasteners holding the radiator shroud to the bumper beam. Remove the two plastic Christmas tree fasteners from each side of the radiator shroud. Guide the side wings of the radiator shroud around the lower brackets. Remove the shroud from the top side, pushing condenser rearward as necessary for clearance. If the shroud does not clear the bumper during removal, it may be easier to free it from the under side of the vehicle.

NOTE: If you do not feel comfortable with performing the modifications to your shroud that are listed in the following steps or you would prefer to keep the existing shroud in stock form, LPE offers an already modified production GM shroud. Contact LPE or your LPE distributor.

Cut out the template, cutting along the outer short dashed line only. Thoroughly clean the shroud to ensure adhesion of tape for the next step. Place the cut template on the shroud as shown, ensuring the line on the template matches up with the crease on the shroud.

Get pdf 2005-2007 Chevrolet Corvette Lingenfelter High Flow Air Intake System Installation Instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: 2005 corvette radio removal, 2007 corvette wiring harness diagram, how to remove radio in 2005 corvette, how do i remove radio frommy2005 corvette, 2005 corvette stero install

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.