This air intake kit requires re-calibration of the factory engine management software. If you do not have a way to re-calibrate the engine control module (ECM), do not install this system until you are able to do so.
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
• Loosen hose clamp at throttle body, pull bellows from the throttle body.
• Work entire assembly free from push pins & remove assembly from car.
• Remove four screws holding top mount radiator shroud & unclip hose from top mount radiator shroud.
• Remove top mount radiator shroud.
• Disconnect electrical connector for under hood light & unclip electrical connector for under hood light from the radiator shroud.
• Disconnect the electrical connector from the outside air temperature sensor located low on the right side of the shroud.
• Remove the two “Christmas tree” push fasteners holding the radiator shroud to the condenser (save the fasteners for reuse). They are located approximately midway up along each side.
• Raise front of vehicle, follow manufacturer instructions. Use jack stands to support vehicle.
Get pdf 2006-2008 Chevrolet Z06 Corvette High Flow Air Intake System
0 comments for this entry ↓
There are no comments yet for this entry.
Leave a Comment