Automotive Manual PDF

RSS Feed

The Resources for Automotive

C6 Corvette SCIC airbox Magnuson Supercharged Applications installation instructions

September 18th, 2008 · No Comments

Disconnect electrical connector for under hood light & unclip electrical connector for under hood light from the radiator shroud. Disconnect the electrical connector from outside air temp sensor located low on the right side of the shroud. Remove the 2 “christmas tree” push fasteners holding the radiator shroud to the condenser. They are located approximately midway up along each side. Raise front of vehicle, follow manufacturer instructions. Use jack stands to support vehicle.

From underneath remove (3) screws holding the front fascia inside the radiator opening. Remove the next screw on either side. These are the screws holding the bottom of the bumper cover. See Picture Remove (2) plastic push pins holding radiator shroud to bumper beam. Remove (2) plastic retainers from each side of the radiator shroud. Guide the side wings of the radiator shroud around the brackets for the last (2) screws that were removed. Remove the shroud from the topside, pushing condenser rearward as necessary for clearance. If the shroud does not clear the bumper during removal it may be easier to free it from the under side of the vehicle. Thoroughly clean shroud to ensure adhesion of tape for the next step.

Get pdf C6 Corvette SCIC airbox Magnuson Supercharged Applications installation instructions

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.