Automotive Manual PDF

RSS Feed

The Resources for Automotive

1993 Suzuki Swift Adjustments

October 15th, 2008 · No Comments

Swift DOHC uses hydraulic lifters. No adjustments are required.
Samurai & Sidekick
1) Remove valve cover. Rotate engine until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. See Fig. 1.
2) Ensure cylinder No. 1 is at TDC on compression stroke. Remove distributor cap. On Samurai and Sidekick (TBI), ensure rotor is pointed upward at distributor hold-down bolt and to No. 1 terminal of distributor cap. On Sidekick (MPI), ensure rotor is at about 1 o’clock position and pointed to No. 1 terminal of distributor cap. If rotor is not as described, rotate crankshaft 360 degrees.
3) Measure valve clearance between adjustment screw and valve stem using shim thickness gauge. Check intake valve clearance of cylinders No. 1 and 2 and exhaust valve clearance of cylinders No. 1and 3. See VALVE CLEARANCE SPECIFICATIONS table.
4) Turn crankshaft one complete revolution (360 degrees). Check intake valve clearance of cylinders No. 3 and 4 and exhaust valve clearance of cylinders No. 2 and 4.
5) Adjust valves by loosening lock nut and turning adjusting screw until clearance is as specified. After adjusting clearance, tighten adjusting screw lock nut to 11.0-13.5 ft. lbs. (15-18 N.m) for Samurai or 90-108 INCH lbs. (10-13 N.m) on Sidekick. On all models, recheck clearance.

Get pdf 1993 Suzuki Swift Adjustments

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: 1993 suzuki swift carburetor rebuild, adjusting ics gti swift, carburetor for 1993 suzuki swift, timingbeltadjustmentsuzukiswift19931 3cu, valve adjustment on a 1993 1 5 suzuki

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.