Automotive Manual PDF

RSS Feed

The Resources for Automotive

Gm Airbag Steering Wheel Replacement Procedures

October 23rd, 2008 · No Comments

This wheel is a direct replacement for your original factory steering wheel with spoke mounted control switches. The original airbag (SIR) module, horn switch, switch harness, switches and shroud from the factory wheel must be removed and transferred to the new GRANT wheel.

This wheel will fit the following vehicles:
Cadillac – 2007-on Escalade, Escalade EXT and Escalade ESV
Chevrolet/GMC –
2007-on Buick Enclave
Buick
2007-on Silverado/Sierra Pickups and Avalanche
2007-on Suburban/Yukon XL
2007-on Tahoe/Yukon and Denali
2007-on Express/Savana Vans
2008- GMC Acadia
Hummer – 2007-on H2

DISABLING AND REMOVAL OF THE AIRBAG MODULE
1. Position the steering wheel so that it is pointed straight ahead. Write down all of your radio presets as these may be lost when you disconnect the battery cable.
2. NOTICE – Disconnect the negative battery cable and wait at least 1 full minute for the circuit to completely discharge before proceeding. CAUTION: Failure to fully deplete the backup power supply could result in an accidental deployment and possible injury.
3. Using a 3-4mm (1/8”-5/32”) Allen wrench release the 2 spring fasteners by pushing inward through the access holes. The access holes are located on both sides of the rear plastic steering wheel shroud. See number 1 in the illustration below.
4. Lift and partially remove the airbag module from the steering wheel in order to expose the electrical connectors on the back side. Take care not to pull on any of the wiring. See number 2 in illustration.
5. The airbag electrical connections have a safety locking connector-position assurance (CPA) clip that must be disconnected before you can remove the electrical connectors from the module.
6. Disconnect the electrical connectors from the airbag module.

Get pdf Gm Airbag Steering Wheel Replacement Procedures

Related Entries


Related Tags: , , , , , , , , , , , , , , , , , , ,


Related Keyword: tool to remove airbag from steering wheel 2010 chevy colorado, gm 12346190 replacement, how to replace steering wheel air bag 1999 gmc sierra, colorado stering wheel airbag, how to remove steering wheel on 2004 colorado

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.