Automotive Manual PDF

RSS Feed

The Resources for Automotive

Tips for Honda CBR 600 F4I/RR Flushmount signal installation

March 2nd, 2008 · No Comments

In order to remover the factory turn signals and install ours, you will need to remove the entire upper fairing. 2.) Remove the original turn signals from the upper fairing. You can cut the connector off the factory turn signals and splice it into the G.C. turn signals. Simply place the G.C. signals into the spot on the fairing left vacant by the factory signals. The wires will go through the large hole in the fairing and the screw will attach through the small hole.

Download pdf (1 page only) Tips for Honda CBR 600 F4I/RR Flushmount signal installation

Related Entries


Related Tags: , , , , , ,


Related Keyword: 2003 cbr 954rr wheel torque, dlc connector cbr, cbr954 rear hub nut torque, cbr600rr DLC connector for sale, cbr 954 wheel torque

0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.