Automotive Manual PDF

RSS Feed

The Resources for Automotive

Entries Tagged as 'Hyundai'

2009-2010 Hyundai Multi Vehicle Mount MVM-35-05 Installation Manual

March 28th, 2010 · No Comments

The Multi Vehicle Mount is an (end user-installer) modifiable professional mounting bracket for most all mobile electronics requiring a steady and secure installation in a motor vehicle. The MVM installs behind your vehicles dash panel using existing or non-visible holes and is designed to cleanly protrude out from your vehicle’s dash panel. Before installing, you must take the time to read and understand this installation manual and read all the warnings accompanying this product.
Instructions Include: tools needed for install, directions for dash panel removal, directions for modifying the MVM if required.
(more…)

[Read more →]

Hyunday H-CSK502 13 CM 2-Way Coaxial Car Speakers Instruction Manual

March 28th, 2010 · No Comments

The owner’s manual contains important operating and maintenance instructions for your safety. It is necessary to refer the manual. Do not install the speakers where they may be subjected to excessive heat moisture, dust or where they will be kicked repeatedly, brushed or bumped. Before mounting and connecting the wires be sure that wire of the negative pole terminal is disconnected from accumulator. Nonobservance of this demand may cause the short circuit or fire. To prevent short circuit never put or leave any metal objects (e.g. coins or metal tools) inside the acoustic system. Make absolutely sure that the terminals for the speakers are connected to the proper outputs from the music source. Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to hide the wiring for safety and a neat appliance.
(more…)

[Read more →]

2003-2005 Hyundai Tiburon V6 Short Ram System Instructions

March 24th, 2010 · No Comments

Removal of the stock intake system.
a. Remove the upper plastic cover covering the stock intake system.
b. Remove the hose clamp securing the upper filter box to the air flow sensor. Unlatch the two clips securing the upper filter box and remove.
c. Remove the filter. Remove the three bolts securing the lower filter box and remove from vehicle.
d. Kit removed from vehicle.
(more…)

[Read more →]

07 Hyundai Santa Fe Side Bar Installation Instructions

March 24th, 2010 · No Comments

Step One: Locate Hardware kit. Check contents with hardware.
Step Two: Remove the front body mount plastic covers.
Step Three: Place the front bolt B plate through the body as shown in pic 2. Attach front support bracket.
Step Four: Place the rear bolt plate through the body as shown in pic 3. Attach rear support bracket.
(more…)

[Read more →]

2010 Hyundai Genesis Coupe L4-2.0L Turbo AEM Dryflow Filter Installation Instructions

March 24th, 2010 · No Comments

1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Jack up the front of the vehicle and support using properly rated jack stands.
f. Do not discard stock components after removal of the factory system.
(more…)

[Read more →]

2005-Up KIA Sportage / Hyundai Tucson Receiver Hitch Installation Instructions

March 10th, 2010 · No Comments

1. Check all parts. Read and understand instructions completely before beginning installation. Clean the under side of the frame. Clean out the weld nuts in the frame.
Parts List:
1) Hitch
6) 10mm – 1.25 x 40mm Hex Bolts
6) ł/₈” HD Flatwasher
6) 10mm Lockwashers
2. Remove the exhaust hangers and lower the exhaust to ease installation.
3. Remove the tow hook, four bolts on the passenger side. Remove the rear most bolt behind the tow hook. Return tow hook and bolts to vehicle owner.
(more…)

[Read more →]

1997-2001 Hyundai Tiburon Cold Air System Installation Instructions

March 10th, 2010 · No Comments

The AEM Cold Air Systems are 50 states Street Legal (some model and years still pending) and come with complete instructions for ease of installation. Our system is constructed of lightweight aluminum and then painted with a zirconia based powder coat for superior heat insulating characteristics. The aluminum will not crack in extended use like plastic and it is actually lighter than plastic. The tube diameter and length are matched for each engine to give power over a broad rpm range. Unlike the plastic systems that use a continually diverging cross section, we take advantage of the acoustical energy in the duct to promote cylinder filling during the intake valve-opening event.
(more…)

[Read more →]

Hyundai Tuscon Engine & Suspension Removal & Replacement Allowances

October 13th, 2008 · No Comments

There have been some changes to time allowances for engine and suspension assemblies on recently scheduled vehicles. Previous schedules have shown separate remove and replace allowances for engines and suspension assemblies of approximately 8.00 to 9.50 hours depending on make and model. When formulated, these allowances reflected a component assembly of the motor, suspension and engine compartment hardware.
(more…)

[Read more →]

Hyundai Sonata 2.4 Manual Sedan Road Test Report

April 11th, 2008 · No Comments

Hyundai’s all new Sonata should be causing its opposition some sleepless nights. Consigning its predecessor’s quirky aesthetics to history, the newcomer’s larger, more attractive “euro” style is just the ticket to generate some showroom traffic. Mix typical Korean value for money with an impressive list of standard safety features, and you have a package set to tug at the purse strings of medium and family car buyers. DISLIKES Clutch action Front seats lack support VALUE FOR MONEY PRICING Kicking off the four cylinder range is our manual test car at $25,490. Add $2,000 for the auto version. Next is the Elite 2.4 (auto only) at $31,490. With high levels of standard equipment the only option for either car is metallic or mica paint at $225. Bear in mind the solid colours are limited to Ebony Black and Noble White. STANDARD FEATURES For the money you receive air-conditioning, power windows on all doors, cruise control, 6 speaker CD, MP3, cassette audio system, remote central locking, front foglights and leather trimmed steering wheel.
(more…)

[Read more →]

Hyundai Sonata V6 Sedan Sample PDF

April 11th, 2008 · No Comments

Performance Standard safety features Normally the domain of local manufacturers, Hyundai’s latest Sonata has stepped on a few toes in the large car segment. Externally the new V6 is almost identical to its four cylinder sibling –dual tailpipes being the only clue to the extra power. Yes, they share the same attractive Euro style body, but have decidedly different personas. DISLIKES Small front seats Light coloured trim marks easily well shaped, fine for a long trip, and the centre armrest is a welcome bonus. But anyone riding in the middle might feel short-changed by the lack of support.
(more…)

[Read more →]