KIT FITS: 1950 – 1964 ½ and ¾ ton Ford pickups and panels F-1, F-100, F-150. These instructions covers Drop Axle Kit as well but steering link and both tie rods are different. KIT INCLUDES: Plates for each side of frame rail with tubes pre-welded and pre-drilled for steering box mounting, seamless heavy wall tubing [...]
Search Results for 1998 ford f150 power steering box diagram
July 22nd, 2009 · No Comments
July 26th, 2008 · No Comments
Vehicles are equipped with an integral housing steering rack that is sealed and must be replaced if defective.
FLUID LEVEL CHECK
Check fluid level when fluid is cold with engine off. To check and fill, remove fluid level gauge from reservoir and check fluid level. Fluid level should be between MIN and MAX marks on gauge dipstick. [...]
December 21st, 2008 · No Comments
This document shows a set of pictures I took while installing a 1999 Subaru Power Steering Rack into my 1973 Datsun 240Z. The car had already been converted to a 1995 LT1 with a WC T5 transmission and I had kept the original pump from the donor car (Caprice 9C1) so I used it.
The steering [...]
March 10th, 2009 · No Comments
This install guide is for the FR500 Steering wheel, which I purchased from AmericanMuscle. It is one of the very few racing-style steering wheels that allow for a stock-for-stock swap from the regular steering wheel. You put the horn, airbag, and cruise control switches back in the original location. The FR500 steering wheel features a [...]
June 20th, 2009 · No Comments
You are the owner of the Power Programmer III, the latest in high-performance tuning technology. Now you can optimize your engine’s tuning, as well as adjust other vehicle parameters (see table of contents), all at the touch of a button. Your vehicle has an onboard computer that controls the engine and transmission. Inside your vehicle’s [...]
August 14th, 2009 · No Comments
1. Engage the steering column / ignition switch lock with the steering wheel & wheels centered. (NOTE It may be necessary to remove the upper and lower steering shaft bolts prior to locking for accessibility)
2. Remove the stock steering assembly by removing the bolts that attach it to the steering box and steering column shafts. [...]
August 17th, 2009 · No Comments
FRONT SUSPENSION INSTRUCTIONS:
1. Disconnect the negative terminal on the battery. With the vehicle on level ground set the emergency brake and block the rear tires. Jack up the front end of the truck and support the frame rails with jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE! Remove the front tires.
2. Locate the torsion bar [...]
May 17th, 2009 · No Comments
Before you install this kit, read and understand all instructions, warnings, cautions, and notes in this instruction sheet and in the vehicle owner’s manual.
Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed [...]
April 30th, 2009 · No Comments
This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a collision or misused, do not install this kit. [...]
July 23rd, 2010 · No Comments
For Speedometer Correction In Toyota Land Cruiser, Hilux/4Runner, Land Rover, Range Rover, Jeep, Suzuki and all other Vehicles fitted with HALL EFFECT Electronic Speedometers. The following instructions are intended as a guide. We recommend purchasing a Toyota workshop manual for your vehicle to verify wiring details.
1. Remove the cover from the back of the interface [...]