I need to replace a fuse in my 1996 Chevrolet Blazer to get my blinker working again. How do I know which one to replace? I do not have an owners manual and there is no guide in the fuse box any longer. Can someone direct me to a link online where I can determine [...]
Search Results for 1999 chevrolet truck fuse block diagram
June 29th, 2013 · No Comments
June 30th, 2013 · No Comments
I have a 1999 Chevrolet Silverado 1500 base Truck will a cold air intake really improve the fuel economy? It is a 4.8 L V8 and it only gets like 14-16 mpg city, i was wondering if a cold air intake, or anything else would improve the gas mileage.
January 8th, 2011 · No Comments
I recently purchased a 1999 Chevrolet silverado and I am not sure if it has keyless entry, I think the remote was lost to it how can I find out if it does?
April 7th, 2009 · No Comments
As delivered by Ford, the factory keyless entry “locks out” when your truck is running. Installing this interface will allow the keyless entry to operate when these conditions are present:
1) Diesel Turbo Lifesaver is running your engine and
2) Ignition key is out of the ignition.
January 7th, 2011 · No Comments
I have a 1999 Chevrolet Blazer and i would like to install a flame kit but since it has a cadylac converter there are not enough fumes left in the exhaust to create a flame. what would be the effect of removing the converter on my horse power, gas mileage, and volume of my truck. [...]
March 10th, 2008 · No Comments
Seats and Restraint Systems This section tells you how to use your seats and safety belts properly. It also explains the air bag system. Features and Controls This section explains how to start and operate your vehicle. Comfort Controls and Audio Systems This section tells you how to adjust the ventilation and comfort controls and [...]
April 9th, 2008 · No Comments
Main wiring diagram, 2.8L Gas Engine, Engine Code AAA Note: For A/C system wiring information for vehicles equipped with the 2.8L Gas Engine, code AAA, see Index for correct Wiring Diagram No. Relay locations Positions of relays and multi-pin connector wiring, see also “Component Locations” sections. Load Reduction Relay Emergency Flasher Relay Wiper / Washer [...]
October 25th, 2009 · No Comments
STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine Driver and Passenger Uprights and Top and Bottom Tubes. (Uprights are positioned so raised side of bolt holes are facing each other and the [...]
September 2nd, 2008 · No Comments
Attaching motor to linkage assembly
The motors must be attached to the linkage assemblies before continuing the installation process.
Steps 1-3 for Heavy Duty Trucks only! For all other vehicles skip to Step 4.
HD – Short Bed: Remove forward most brake cable guide.
HD – Long Bed: Remove first and third brake cable guide.
October 4th, 2009 · No Comments
1. Disconnect the negative battery cable! Remove the plastic wing nut on the air intake hat behind the throttlebody. Loosen the hose clamp that secures the flexible intake tube to the throttle body hat. Disconnect the crankcase breather hose. Roll the air intake hat towards the front of the vehicle to remove it, and set [...]