Automotive Manual PDF

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall […]

[Read more →]

Step I:
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available.
First, remove driver side front wheel, then unbolt upper shock mounting nut.(A) Next remove lower shock mounting nut and […]

[Read more →]

Trucks with lift kits or leveling kits installed have a higher center of gravity. Aggressive direction changes may cause a tip over. Always drive carefully and obey the speed limit.
1. FRONT SUSPENSION—remove axle nut to prevent the CV joint form coming apart.
2. Remove three nuts from under plastic plugs under hood. These attach the upper […]

[Read more →]

FRONT DISASSEMBLY:
1. With vehicle on flat level ground set the emergency brake and block the rear tires. Place floor jack under the lower control arm’s front cross member and raise vehicle. Place jack stands under frame rails, behind the front wheel wells then and lower the frame onto the stands.
2. Remove both front factory skid […]

[Read more →]

Zone Offroad Products recommends this system be installed by a professional technician. In addition to these instructions, profes-
sional knowledge of disassembly/ reassembly procedures and post installation checks must be known. Minimum tool requirements
include the following: Assorted metric and standard wrenches, hammer, hydraulic floor jack and a set of jack stands. See the “Special
Tools Required” section […]

[Read more →]

This kit has been specifically engineered for the 2000 to current GMT 820 series ½ Ton Sport Utility Vehicles. Please note that this Belltech lowering kit will lower these vehicles approximately 2 inches in front and 3 inches in the rear. We DO NOT RECOMMEND using this lowering kit on vehicles where other aftermarket suspension […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall […]

[Read more →]

FRONT DISASSEMBLY:
1.With vehicle on flat level ground set the emergency brake and block the rear tires. Place floor jack under the lower control arm’s front cross member and raise vehicle. Place jack stands under frame rails, behind the front wheel wells and lower the frame onto the stands.
2. Remove both front factory skid plates located […]

[Read more →]

Adjusting Lift/Leveling kit after installation
(1) Always wear proper eye protection! Position vehicle on a stable,flat surface and suspend front wheels, lifting by the frame with a floor jack or lift jack. Secure frame with jack stands. Chock tires and turn engine off prior to adjustment!
(2) Locate the two Torsion Key Adjusting Bolts in the cross […]

[Read more →]