Automotive Manual PDF

For many years the number of plates per cell was taken as a guide to the engine cranking power provided by the battery. However, over time this criteria proved to be misleading. Starting power is a function of the area of plate surface exposed to acid. If all plates were the same size (and therefore […]

[Read more →]

1. Raise vehicle and support with jackstands on a stable surface.
Note: Vehicle must be supported with vehicle’s normal weight on rear axle. Do not support vehicle by its trailing arms.
2. Remove only one of the stock lower trailing arms.
3. Install the Edelbrock lower trailing arms with the spherical ball at the rear axle mounting point […]

[Read more →]

The CamFC has an AFC (air/fuel controller) onboard so that the fundamental fuelling issues related to the addition of tuning accessories such as extractors, exhausts, adjustable cam gears, filters and mild cams can be resolved. The Cam switching point is adjustable in 1 RPM increments and the switch off point is adjustable as well.

[Read more →]

For breaker points, the 5 ohm coils should be used or the 3 ohm coils can be used and a 1 to 2 ohm ballast resistor placed in the 12 volt line going to the coils. Generally, a ballast resistor should not be used with DYNA COILS on electronic ignitions. The secondary towers are designed […]

[Read more →]

The GNA600 is a vehicle interface device with the speed and storage capacity required to update control units/modules in vehicle systems that use the CAN (control area network) communications protocol on the DLC (data link connector). The GNA600 does all the functions of the HIM (Honda Interface Module) but with additional capabilities. The GNA600 is […]

[Read more →]

These shocks are pressurized with nitrogen to 250 psi. Normally there is no reason to change the nitrogen pressure in the shocks. It is not intended as an air shock which can be made stiffer or softer with changes in pressure. The use of standard automotive-type air chucks and gauges will allow the oil in […]

[Read more →]

The installation of the supplied high pressure fuel pump requires removing and reinstalling the fuel tank. An automotive lift makes this job much easier. The fuel tank can be removed with the car on jack-stands, provided you have the car high enough, and an assistant ready to help you. Our recommendation is to use an […]

[Read more →]

1. Remove contents and check for damage. Verify all parts are present. Read instructions completely before installation.
2. Locate driver side mounting locations on vehicle (See Figure 1and 2). Repeat for passenger side.
3. Attach driver side front and rear mounting brackets to underside of rocker panel as shown using M8 hex bolts, 5/16” flat washer and […]

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine passenger and driver mount brackets from figure above.
STEP 4. Remove the (16) push type retainers and (2) 6mm bolts from the lower splash shield. […]

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list. Read and understand instructions completely before beginning installation.
STEP 2. Measure, and mark clearly, from the front of pinch weld towards the rear of vehicle for bracket positions. Suggested locations at 14 1/2”,33 1/4”, 49 1/2” […]

[Read more →]