Automotive Manual PDF

Your new Daystar body lift kit will allow the installation of 35” tires. Larger tires can be fitted if paired with our 2” torsion bar key kit, and some trimming . The tools needed for installation are on the last page . A list of parts in the kit are under the BOM, verify that […]

[Read more →]

The CamFC has an AFC (air/fuel controller) onboard so that the fundamental fuelling issues related to the addition of tuning accessories such as extractors, exhausts, adjustable cam gears, filters and mild cams can be resolved. The Cam switching point is adjustable in 1 RPM increments and the switch off point is adjustable as well.

[Read more →]

STEP 1: REMOVE PLYWOOD & INVENTORY CONTENTS
Remove the top cover from the canister box and set it aside for later installation.
Remove the canister from the box. Using the 3/8” wrench or socket remove the 2 bolts holding the plywood on the ends of the canister. Use Side Cut Pliers to cut handle retaining straps. DISCARD […]

[Read more →]

Tools Recommended: metric deep socket set, metric & American open end wrench set, 9/64th Allen wrench, Teflon tape, wire cutters, terminal crimpers.
Follow the included diagram exactly. This product uses two different but visually similar threads. 1/8” NPT and 1/8” BSPT may appear to be the same thread, but they are not. Do not assemble any […]

[Read more →]

Before you begin please make sure you are installing these keys on an HD series Chevrolet or GMC truck. These keys will not work on a standard 1500 series ― ton Silverado or Sierra. These are for HD models only.
Working with torsion bars can be dangerous! Follow ALL precautions when installing the leveling keys. The […]

[Read more →]

If your truck does not have a locking tailgate (like provided on many full size Fords, Toyotas and Nissans), you will need to purchase an aftermarket tailgate lock (i.e., Pop’ N Lock, Bully Tailgate Lock, etc.,) to be able to lock the tailgate shut and to secure your truck bed. These lock sets basically replace […]

[Read more →]

Zone Offroad Products recommends this system be installed by a professional technician. In addition to these instructions, profes-
sional knowledge of disassembly/ reassembly procedures and post installation checks must be known. Minimum tool requirements
include the following: Assorted metric and standard wrenches, hammer, hydraulic floor jack and a set of jack stands. See the “Special
Tools Required” section […]

[Read more →]

Removal of stock system:
First using 15mm socket or wrench, remove four (4) nuts at flange located approximately under the passenger side seat. Remove rear exhaust from rubber hangers and remove the system from under the truck.
NOTE: If you have purchased the optional front pipe, Remove the stock front pipe on the truck by removing the […]

[Read more →]

Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2. Using a 15mm socket or wrench, disconnect the factory exhaust system at the four bolt flange located behind the catalytic converter. If the vehicle is not equipped with a catalytic converter disconnect the four bolt flange located approximately […]

[Read more →]

These instructions are to insure proper installation, which will enhance the safety and reliability of your Jet Trax System. The Jet Trax System is designed to provide years of dependable service without undue maintenance cost or operations problems. By following these step-by-step instructions, your Jet Trax System will become a secure and reliable transporting and […]

[Read more →]