Automotive Manual PDF

RSS Feed

The Resources for Automotive

Search Results for diagram of 2002 ford explorer fuel filter location

Can a 99 ford explorer engine fit in a 99 ford ranger?

December 16th, 2010 · No Comments

Problem: I have a 99 ford ranger that has a blown motor and i found a 99 ford explorer engine and i think a ford ranger and ford explorer are the same. Without changing motor mounts.

[Read more →]

Tags: Ford

VW TDI Engines Caterpillar 2 Micron Fuel Filter Kit Installation Instruction

August 5th, 2008 · No Comments

1. Install the large o-ring on the threaded nipple on the bottom of the Filter Adapter.
2. Using a little diesel fuel, lubricate the filter gasket and thread the fuel filter onto the filter adapter by hand. Once the filter is on the adapter hand tight tighten the filter one additional complete turn, using a pair [...]

[Read more →]

Tags: Volkswagen

99-2003 Ford 7.3L fuel pressure gauge install

March 22nd, 2009 · No Comments

The fuel pressure gauge used on the 7.3L Ford is a 0- 100 psi mechanical gauge and needs to be installed using a fuel isolator to ensure diesel fuel cannot enter the trucks interior due to a gauge or tubing failure. Install the gauge into the gauge mount with the tubing connected to the back [...]

[Read more →]

Tags: Ford

Ford Explorer Sport TracTXO Instructions

July 11th, 2009 · No Comments

Ford Sport Tracs, because of their unique nature, require additional assembly procedures to install the side rails. A set of support brackets and hardware have been included with your TruXedo® kit in place of the clamp assemblies used on standard pickup boxes. These have been especially designed to fit your Sport Trac composite box.

[Read more →]

Tags: Ford

How can I get Ford Galaxy engine guide with parts location?

December 16th, 2010 · No Comments

Problem: I suspect my car is not working because “AIR FLOW MASS METER SENSOR FORD GALAXY 1.9 TDI” is not functioning properly, I’d like to peak inside engine to check where to find this part so I can replace it.

[Read more →]

Tags: Ford

1995-2007 Ford Ranger – 1995-2001 Ford Explorer Mercury Mountainer Installation

May 28th, 2009 · No Comments

Locate four small holes on the face of the radio. Insert the (Ford Radio Removal DIN Tools) into these holes until you hear and feel a light click. Press outward on the DIN tools while at the same time pulling on them to slide the radio out of its cavity. Disconnect any wiring to the [...]

[Read more →]

Tags: Ford

1998 Ford Explorer Mirror-Beam Model MBEX98 Installation Guide

March 19th, 2009 · No Comments

To Remove the Side Mirror Assembly:
1. Remove the door panel from the vehicle.
2. Remove the nuts that secure the mirror housing to the vehicle. Unplug the mirror’s harness cable from the door’s power harness.
3. Carefully remove the mirror housing from the vehicle.

[Read more →]

Tags: Ford

Ford 4.0 L Ranger & Explorer Power-Plus Series Throttle Body Installation Instructions

March 27th, 2009 · No Comments

Step 1
Set parking brake on vehicle and disconnect the negative battery terminal.
Step 2
Remove flexible inlet hose from throttle body and air box by loosening two hose clamps. Disconnect the tube to the valve cover and the inlet air temperature sensor if applicable.
Step 3
Remove plastic cover on the left side of the throttle body. Unhook the [...]

[Read more →]

Tags: Ford

Minimum fuel octane requirement for 2002 Mercedes Benz CLK320 ?

January 4th, 2011 · No Comments

Have a 2002 Mercedes Benz CLK320 with a V6 engine, and I would like to know if it’s OK to use 87 octane gas to save some money. My owner’s manual says that the minimum fuel octane I have to use is supposed to be 91, but considering today’s gas prices I’d like to use [...]

[Read more →]

Tags: Mercedes-Benz

BMK-21 Single Mount By-Pass Filter System Installation and Servicing Instructions

July 31st, 2009 · No Comments

This filter system is not designed to replace the engine’s normal full-flow filter. Do not attempt to install a by-pass filter element in place of the existing full-flow filter.
WARNING: Extreme care should be taken to avoid bodily harm during installation. Before starting, ensure the engine is cool to avoid burns and never work in the [...]

[Read more →]

Tags: Misc