Main wiring diagram, 2.8L Gas Engine, Engine Code AAA Note: For A/C system wiring information for vehicles equipped with the 2.8L Gas Engine, code AAA, see Index for correct Wiring Diagram No. Relay locations Positions of relays and multi-pin connector wiring, see also “Component Locations” sections. Load Reduction Relay Emergency Flasher Relay Wiper / Washer [...]
Search Results for diagram of wiring for 2002 gmc sierra fuel pump
April 9th, 2008 · No Comments
June 3rd, 2008 · No Comments
To avoid exceeding the maximum ratings in any condition, the voltages must be checked with no load at the power supply output.
Wiring Using the Screw Terminals
WARNING Make sure that you connect only de-energized wires.
October 10th, 2011 · No Comments
I have a Nissan Pathfinder with 162,000 miles on it. I have never replaced the fuel pump on it. I am currently not having any problems with the pathfinder running. I am taking it to the shop to get the fuel filter changed soon should I get the fuel pump replaced also due to he [...]
September 14th, 2008 · No Comments
1. CHECK FUEL PUMP OPERATION
(a) Using SST, connect terminals +B and FP of the data link connector 1.
(b) Turn the ignition switch ON.
NOTICE: Do not start the engine.
(c) Check that there is pressure in the hose from the fuel filter.
September 6th, 2008 · No Comments
LPE offers this in-tank fuel pump for high performance applications where the standard pump is not capable of supplying sufficient fuel flow. Designed to fit the 1997 through early* 2003 C5 Corvette. This pump is rated at 225 liters/hour (60 gph) at 60 psi of fuel pressure at 13.5 volts. This is sufficient to handle [...]
August 14th, 2008 · No Comments
I suggest doing this all before installing the clutch pedal, it is a tight spot to work in.
1. REMOVE Park Neutral Relay 175
2. Pull out the socket for the 175 to get access to the wires CRUISE CONTROL HOOKUP portion
3. Cut the GREEN/BLACK wire (pin #5) close to the 175 socket and connect to [...]
September 25th, 2008 · No Comments
If you have a high mileage vehicle, we recommend changing the fuel filters inside the module. The primary fuel filter and the inlet filter sock are not currently available as service parts from GM so changing these filters requires purchasing an all new fuel pump module. Complete fuel pump modules are available from LPE (see [...]
January 15th, 2011 · No Comments
I have looked under the back seat and there are two covers if the fuel pump is under one of them what is the other for ?
- Its the one under the passenger sode. thats the access you want.
remove the access cover. press the green unlocking ring and detach fuel delivery hose. disconnect other hoses. [...]
November 5th, 2009 · No Comments
This document describes car models to which the Super Airflow Converter (Product code: 401-A911/401-A913) is applicable, and ECU terminal arrangement drawings. For the operating method and precautions for the Super Airflow Converter, refer to the Instruction Manual. When installing the Super Airflow Converter, both this document and the Instruction Manual are required. Even if the [...]
December 27th, 2010 · No Comments
I have an odd problem with my car. It MUST be the fuel pump because I just replaced the fuel filter. My car will start up and run for about 5-10 minutes, then it stalls. There is an odd sound coming from near the rear end while it’s running and I’m assuming it’s coming from [...]