Automotive Manual PDF

Step I:
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available.
First, remove driver side front wheel, then unbolt upper shock mounting nut.(A) Next remove lower shock mounting nut and […]

[Read more →]

Your new Daystar body lift kit will allow the installation of 35” tires. Larger tires can be fitted if paired with our 2” torsion bar key kit, and some trimming . The tools needed for installation are on the last page . A list of parts in the kit are under the BOM, verify that […]

[Read more →]

Step 1: Applies to H3 ONLY, for Colorado/Canyon please skip to step 2.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available.
First, remove driver’s side front wheel, then unbolt […]

[Read more →]

SECTION 1: PRE-INSTALLATION PRECAUTIONS:
Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located in your owner’s manual. If you cannot find the radio code, take your car to your local Honda dealer so that they can retrieve the code through […]

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Bolt mount brackets to vehicle body mounts using metric bolts provided in parts kit. See figure 1.
STEP 4. Position step bar up to the mount […]

[Read more →]

This document covers the installation of RECON Truck Accessories 3-Piece running lights on a 2003 Chevrolet/GMC Silverado/Sierra 2500 HD. RECON 3-piece Chevy/GMC Cab Roof Light Kit Boasts The Following:
Provides Maximum Visibility
Meets S.A.E. specifications
Adapts to Curved and Flat Roofs
Replaceable 194-Style Bulbs
Kit includes 2 Corner Clearance Lights and 1 Three Lamp Cluster Center Marker Light
Complete Wiring Harness […]

[Read more →]

1. Assemble your motor/bracket assembly. Your actuators came with two Phillips head screws. Use these to secure your the actuator to the bracket.
2. Remove the door panel and 3 torque screws that hold the latch. For most GM vehicles, screw size is T30.
3.Using a pick or similar tool, un-snap the plastic retaining clip that holds […]

[Read more →]

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified.
4. Special tools needed:
a. 17/64” & 5/16” drill bits
b. Tool to trim […]

[Read more →]

Step Installation: Complete Part One, then find the section for specific instructions for your model vehicle.
Part One: Rear bracket attachment
Step 1) Attach the rear brackets to the step as shown in Figure 1, using a washer, E, and nut, I, on each stud. Tighten each nut.
Step 2) Place the cross member in position as shown […]

[Read more →]

Please gather the following tools before you begin the installation: * Power Drill. * 3/16 drill bit. * Large flat head screw driver. * Large Phillips head screw driver. * Sharp utility knife or razor blade. * Fine permanent marker. * Center punch & hammer - optional. Step 2 - Unpack Dead Pedal kit and […]

[Read more →]