Automotive Manual PDF

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.
Installation Procedure
• Unscrew the gas cap to release residual pressure in the fuel […]

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.
Installation Procedure
• Screw the 90* fittings into the top and bottom of the […]

[Read more →]

Removal of stock system:
First using 15mm socket or wrench, remove four (4) nuts at flange located approximately under the passenger side seat. Remove rear exhaust from rubber hangers and remove the system from under the truck.
NOTE: If you have purchased the optional front pipe, Remove the stock front pipe on the truck by removing the […]

[Read more →]

Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2. Using a 15mm socket or wrench, disconnect the factory exhaust system at the four bolt flange located behind the catalytic converter. If the vehicle is not equipped with a catalytic converter disconnect the four bolt flange located approximately […]

[Read more →]

Installation Step:
1. Disconnect the negative battery cable. Using a 5/16” socket or flat screwdriver, loosen the hose clamp that holds the factory airbox to the flexible intake tube.
2. Using a #20 Torx bit, remove 2 screws holding the Mass Air Flow sensor to the factory airbox tube. Remove the MAF and set it aside. Remove […]

[Read more →]

Removal of stock system:
First using 15mm socket or wrench, remove four (4) nuts at flange located approximately under the passenger side seat. Remove rear exhaust from rubber hangers and remove the system from under the truck.
NOTE: If you have purchased the optional front pipe, Remove the stock front pipe on the truck by removing the […]

[Read more →]

Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2. For 2001-2005 vehicles use a 15mm socket or wrench and disconnect the factory exhaust system at the four bolt flange located behind the catalytic converter. If the vehicle is not equipped with a catalytic converter disconnect the four […]

[Read more →]

For Chevrolet / GMC models 2500 & 3500, model years 2001-2008, with Duramax diesel engines: Extended Cab Short and Long Bed: also Crew Cab Short and Long Bed.
Note: Each tank has the above identification designation on its top. Please check to be sure the tank is properly identified as the one to fit your truck.

[Read more →]