Automotive Manual PDF

Performer series intake manifolds are compatible with aftermarket camshafts and headers designed to operate in the idle-5500 RPM range. Edelbrock offers a dyno-matched, street proven camshaft; Performer-Plus #2172. Header primary tube diameter should be 1-5/8” depending on your specific engine combination.

[Read more →]

Edelbrock Performer series intake manifolds are designed for engines operating in the idle to 5500 rpm range. Performer RPM series intake manifolds are designed for engines operating in the 1500-6500 rpm range. Match Performer or Performer RPM intake manifolds with recommended carburetors and additional equipment for even greater performance increases.
EGR SYSTEMS: Edelbrock EGR-equipped Performer manifolds […]

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen clamp at intake manifold leaving clamp on hose.
3. Slide hose tube assembly back and insert power plate into hose.
4. Reinstall tube hose assembly making sure power plate is engaged in tube while locating and tightening hose clamp.

[Read more →]

This kit is designed to allow the installation of hydraulic roller cams in standard Ford 302 HO V8 engines originally equipped with hydraulic roller cams. In order to use this kit, your engine must have two bosses cast into the block (fig. 1) in the lifter valley area. These bosses may or may not be […]

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake assembly.
3. Remove (2) bolts & save from linkage bracket. (Ref. C)
4. Remove (4) bolts from the throttle body. (Ref. D)
5. Remove gasket and clean surfaces.

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Remove (2) 8mm bolts from throttle linkage bracket and save. (Ref. D)
4. Remove (4) bolts from the throttle body. (Ref. C)

[Read more →]

Step 1
Set parking brake on vehicle and disconnect the negative battery terminal.
Step 2
Remove flexible inlet hose from throttle body and air box by loosening two hose clamps. Disconnect the tube to the valve cover and the inlet air temperature sensor if applicable.
Step 3
Remove plastic cover on the left side of the throttle body. Unhook the […]

[Read more →]

Someone who has a basic knowledge of automobile repair and modification and is familiar with and comfortable with working on their vehicle can accomplish the mechanical installation of this kit using common tools and procedures. However, this kit is designed to allow you to custom fit the fuel lines and components to your application, and […]

[Read more →]

Someone who has a basic knowledge of automobile repair and modification and is familiar with and comfortable with working on their vehicle can accomplish the mechanical installation of this kit using common tools and procedures. However, this kit is designed to allow you to custom fit the fuel lines and components to your application, and […]

[Read more →]

DO NOT try to run the vehicle at full throttle at sea level altitude with a supercharger unless the fuel tank is filled with good 91-octane fuel. Failure to heed this warning can result in severe engine damage. Special Note: If you do not have a factory workshop manual, buy one now! It is good […]

[Read more →]