Automotive Manual PDF

This Kit must be installed with THE EDGE 4.5” HANGER KIT (part no.3-4000) or THE EDGE 6” FRONT SPRING KIT (part no.3-6000) or THE EDGE 8” FRONT SPRING KIT (part no.3-8000).
- Front Driveshaft for 8” Front Spring kit must be modified.
INSTRUCTIONS:
1. Jack up the front end of the truck and support the frame at the […]

[Read more →]

While this kit is an easy bolt-on system, Rize Industries, LLC. strongly recommends that a professional installation center be contracted to do the install. Rize Industries, LLC. also recommends using a hydraulic lift when performing this installation.

[Read more →]

Step 1. Before you remove anything off the truck, measure the pinion on the front and rear axle differential. Make sure to record this measurement as we will want to put each axle back to this angle after the suspension lift kit is installed. This is especially important for the front axle. Putting the front […]

[Read more →]

Volvo co-build with Renault (who use it in the R11 and R21) and which also appears in Volvo’s 300 series. For the 480 though, it’s gained multi- point fuel injection and Bosch engine management electronics. Power has risen to 109bhp at 5800rpm (up from the 81bhp of the carburettor version) with torque of 103lb ft […]

[Read more →]

2007 Suzuki Forenza and Forenza Wagon
ENGINE
Type: 2.0-liter, in-line four-cylinder, 16-valve DOHC
Materials: Cast iron cylinder block/aluminum cylinder head
Displacement: 2.0 liters (2,000 cc/122 cu. in.)
Bore x stroke: 86.0 mm x 86.0 mm/3.39 in. x 3.39 in.
Compression ratio: 9.6:1
Horsepower: 127 hp @ 5,600 RPM
Torque: 131 lb.-ft. @ 4,200 RPM
Valves per cylinder: Four
Fuel system: Electronic multi-port fuel injection, variable […]

[Read more →]