Automotive Manual PDF

The E30 3-Series range first became available in the UK in March 1983, and continued in production until April 1991, when the revised E36 3-Series range (not covered by this manual) was introduced. Convertible and Touring (Estate) models were introduced for 1988, and these models have continued in E30 form to date.
The E28 5-Series models […]

[Read more →]

INSTALLATION INSTRUCTIONS
1. Disconnect the negative terminal on the battery. Jack up the front end of the truck and support the frame rails with jack stands. Remove the front tires. NEVER WORK UNDER AN UNSUPPORTED VEHICLE!
2. Starting on the driver’s side of the truck, remove the nut securing the tie rod end to the spindle. Using […]

[Read more →]

INSTALLATION
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery.
Removing the vehicle parts
3. Shift the select knob to “D” position by pressing down on the shift lock stopper with the ignition key. Remove the left side center panel (eight clips […]

[Read more →]

Step 1:
Identify the key components that complete our brake line kit: You should have nine (9) hoses, one (1) double banjo bolt, fourteen (14) single banjo bolts, (1) single bleeder bolt three (3) drawings, and a picture CD. There are also a total of forty (40) washers and two (2) “olive” conic inversors. Thirty six […]

[Read more →]

INSTRUCTIONS:
1. Disconnect the negative terminal on the battery. With the truck on level ground measure the trucks ride height from all four corners. Record the heights for use in the installation of the kit.
2. Jack up the front end of the truck and support the frame rails with jack stands. NEVER WORK UNDER AN UNSUPPORTED […]

[Read more →]

INSTRUCTIONS:
1. Disconnect the negative terminal on the battery. Jack up the front end of the truck and support the frame rails with jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE! Remove the front tires.
2. Working from both sides of the truck, remove and discard the factory sway bar end links from the truck. Remove the […]

[Read more →]

Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available. Make sure that the emergency brake is on and the rear wheels are blocked […]

[Read more →]

This Kit must be installed with THE EDGE 4.5” HANGER KIT (part no.3-4000) or THE EDGE 6” FRONT SPRING KIT (part no.3-6000) or THE EDGE 8” FRONT SPRING KIT (part no.3-8000).
- Front Driveshaft for 8” Front Spring kit must be modified.
INSTRUCTIONS:
1. Jack up the front end of the truck and support the frame at the […]

[Read more →]

1. With the truck on the ground, remove the track bar bolt at the differential Lift truck up, and make sure it is safe by using jack stands or a 2-post lift that locks in place.
1. Support the front axle with a support jack equipped with the proper fixture.
2. Undo the sway bar links.
3. Undo […]

[Read more →]

LIFT INSTRUCTIONS:
1. Disconnect the negative terminal on the battery. Jack up the front end of the truck and support the frame, at the front frame rails, with jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. Remove the front tires.
2. Remove the brake calipers and tie them up out of the way. DO NOT ALLOW THE […]

[Read more →]