Automotive Manual PDF

These components are designed to improve the exhaust efficiency of the GM C.P.I. (Central Port Injection) V8 engine. This system does not require welding for installation and retains all O.E.M. emissions equipment. These Edelbrock headers are street legal in all 50 states.
Suggested Tools Needed for Installation. This vehicle has metric fasteners:
- 3/8″ ratchet socket set […]

[Read more →]

The RSM (Rev Speed Meter) is a multi function measuring device designed to measure and monitor vehicle speed, RPM, 0-400m time, mid range acceleration, estimated horsepower, as well as acceleration G.(Using optional G Sensor)
- Easy to Read VFD (Vacuum Fluorescent Display)
The RSM utilizes and easy to read VFD screen in a highly stylish case which […]

[Read more →]

A factory service manual is necessary to perform this installation. Do not attempt to perform this installation if you are not confident in your ability to perform all steps in the procedure, including precise drilling and tapping; consult a trained technician.
Procedure remove the stock aIr cleaner and carburetor
steP 1 Remove the seat, dash panel, and […]

[Read more →]

Front / Rear & Poly Spring Pads (PSP’s)
The SSA10 springs do NOT have a specific left or right side; however, they do have a specific front / rear side. Position the two-hole shackle to the front and the three-hole shackle to the rear. PLEASE NOTE: Two sets of PSP’s are included with these springs. The […]

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Bolt mount brackets to vehicle body mounts using metric bolts provided in parts kit. See figure 1.
STEP 4. Position step bar up to the mount […]

[Read more →]

STEP 1. Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning
STEP 2. Determine passenger and driver uprights and center section assembly and assemble as shown. Hand tighten all fasteners centered in slots or holes. Be sure dimple in ring mount plate is to the top.
STEP […]

[Read more →]

Installation Instructions. Read Me!
I. DISCONNECT NEGATIVE (-) BATTERY CABLE
II. Remove Factory Intake Assembly
a) Loosen the factory hose clamps on each end of the factory intake tube assembly.
b) Using a flat head screwdriver, gently pry the radiator hose bracket from the factory intake tube assembly and remove from vehicle.

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.
Installation Procedure
• Unscrew the gas cap to release residual pressure in the fuel […]

[Read more →]

Remove the Stock / OEM Instrument Panel
1) Make sure to disconnect the vehicle battery before you begin to remove the instrument panel.
2) Remove the two 5/16” screws which are holding the steering column tight to the base of the dash. This allows the steering column to drop down slightly.
3) Remove the six screws that are […]

[Read more →]

Remove the contents from the box and check for any damage. Verify all parts against the parts list.
Read and understand instructions completely before beginning installation.
Remove 10mm bolts from bumper brace located on back side of front body mount if present. For each side, place Mount Bracket up to the backside of the body mount and […]

[Read more →]