Automotive Manual PDF

Installation Instructions. Read Me!
I. DISCONNECT NEGATIVE (-) BATTERY CABLE
II. Remove Factory Intake Assembly
a) Loosen the factory hose clamps on each end of the factory intake tube assembly.
b) Using a flat head screwdriver, gently pry the radiator hose bracket from the factory intake tube assembly and remove from vehicle.

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.
Installation Procedure
• Unscrew the gas cap to release residual pressure in the fuel […]

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.
Installation Procedure
• Screw the 90* fittings into the top and bottom of the […]

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit Includes
Installation bracket/s, cable ties EFI multi port fuel injection hose with Male/Female quick connect fittings (Not included – Ford Fuel Line disconnect tool No. 7336 – available at your local Ford Dealer or see […]

[Read more →]

1) Disconnect the vehicle’s negative battery cable.
2) Carefully remove the electrical plug at the mass-air sensor. (held in place by a small spring-wire clip) Move the wire out of harms way until re-assembly.
3) Loosen the intake tube where it connects to the mass-air sensor.
4) Unbolt the airbox assembly from the body. It is held in […]

[Read more →]

Visual Inspection– Many vehicles have a large area in which to mount the Questar® spotlight. In addition to the location specified above, you should be able to find other locations that will allow the mounting of additional optional equipment on the roof. Some headliners have optional overhead storage compartments. Always try to mount the Questar […]

[Read more →]

This is an install document for a High Intensity Discharge Kit for the Volvo S40. This is a fairly simple procedure and should take approximately 45 minutes to install.
Kit Details
DDM HID Kit including:
2 – Ballasts and Igniter assemblies
2 – HID Bulbs w/wire assemblies
2 – Ballast to Bulb connecting wires
2 – 3M Double sided adhesive tape

[Read more →]

1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier to install the bulbs first.
2. Remove the access cap from the rear of your headlight housing as shown.
3. Drill a hole in the center of the cap as shown. […]

[Read more →]

The tools you needs:
A drill with a smaller bit such as a 1/4″
A dremel or similar to cut a hole in plastic
T27 Torx bit and driver with 4” extension
Extendable magnet
Pliers
1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier […]

[Read more →]

1969 CHEVROLET CORVETTE L88 COUPE Matching number car. A real L88 with original motor and original Corvette Order Copy. Only 116 L88 Corvettes built in 1969. The L88’s were intended for one purpose - to race. 2487 1969 CHEVROLET CORVETTE ROADSTER 350 CI/300 HP, automatic transmission. 2495 1969 CHEVROLET CHEVELLE SS 396 Body on frame […]

[Read more →]