Automotive Manual PDF

1. Locate the oil filter flange on your motor and find the stock oil pressure sender. To access this location fully, certain emissions devices or the intake manifold may need to be removed. Remove the wiring harness from the stock oil pressure sender and move aside. Using a 24mm deep socket, unscrew the sender.
2. Install […]

[Read more →]

Start with your Phillips head screw driver and remove the three screws on top of your battery cover. Then remove the battery cover from the car. Firmly grasp the plug on top of your MAF sensor unplugging it. Lay the plug back away from the intake system. Using your Phillips head screwdriver loosen the hose […]

[Read more →]

What’s included with your package:
• One HyperBoost diverter valve
• Two medium sized hose clamps
• One small hose clamp
• One instruction sheet (you are reading it)
Tools required for your installation:
• A medium sized flat-blade screwdriver
• Tin snips
• Regular or needle nose pliers
• A bit of motor oil or vegetable oil

[Read more →]

primary harness (H1) wire connection guide
primary harness (H1) wiring diagram
The primary harness supplied with this unit is the standard 12-pin harness used. Two wires in the plug are not used. The upgrade from this unit to a security system would simply require unplugging and exchanging control units and connecting the necessary wires to the vehicle. […]

[Read more →]

Some different models or years of vehicle may use different sized fasteners. Every effort has been taken to correctly identify the proper sized tool for each job. Occasionally, the manufacturer may use an alternate fastener. Check that each tool correctly fits the fastener before loosening or tightening it. The following tools and equipment will be […]

[Read more →]

1. Removal of the original bumper:
Remove all screws which hold the bumper. Also remove the screws which hold the alloy bar and remove the bumper with the alloy bar. Remove the alloy bar from the bumper and install it into the new Hofele-Design bumper.
2. Placement of the Hofele-Design front bumper on the car:
Place the new […]

[Read more →]

FUNCTIONS
·Data fault repair of Audi/VW/Opel airbag modules
·Crash data reset of Audi/VW/Opel airbag modules
HARDWARE
·Yellow -Button is used to repair data fault
·Red -Button is used to reset crash data
·Led-Indicators are used to indicate the operating state, while the red led indicate ‘power on’, the green led indicate ‘busy’ and ‘error’, and the yellow led indicate ‘usb port […]

[Read more →]

The tools you needs:
A drill with a smaller bit such as a 1/4″
A dremel or similar to cut a hole in plastic
T27 Torx bit and driver with 4” extension
Extendable magnet
Pliers
1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier […]

[Read more →]

This interface should be used to display fixed menus during your journey, for example the MP3 menu for DVD upgrades. The driver of the vehicle must never be distracted by moving pictures. In most countries/states, watching movies whilst driving is prohibited. Therefore, we do not accept any liability for material damage or personal injury resulting, […]

[Read more →]

This operation manual details the use of the device contained in the package. It is recommended to look for an experienced technician for device installation.
Warning
Changes or modifications not expressly approved by the manufacturer will void the warranty and the user’s authority to operate the device.
This device complies with Radio Frequency Rules in respective countries.
Operation is […]

[Read more →]