Automotive Manual PDF

When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the vehicle, set parking brake, block tires and use safety glasses and gloves. Allow exhaust to cool before attempting installation. Severe injury or burns could occur if safety measures are not taken.
SUGGESTED TOOLS: 1/2″, 9/16″, 12,14,15mm wrenches […]

[Read more →]

When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the vehicle, set parking brake, block tires and use safety glasses and gloves. Allow exhaust to cool before attempting installation. Severe injury or burns could occur if safety measures are not taken.
SUGGESTED TOOLS: 1/2″, 9/16″, 15mm wrenches […]

[Read more →]

Installation Instructions. Read Me!
I) DISCONNECT NEGATIVE (-) BATTERY CABLE.
II) Remove the Factory Air Box
a) Loosen Mass Air Meter hose clamps and set meter aside.
b) Unbolt the three air box hold down fasteners and save the bolts. See Fig#1
c) Lift out & remove the factory air box assembly from vehicle.
d) Remove and save the three rubber […]

[Read more →]

These components are designed to improve the exhaust efficiency of the GM C.P.I. (Central Port Injection) V8 engine. This system does not require welding for installation and retains all O.E.M. emissions equipment. These Edelbrock headers are street legal in all 50 states.
Suggested Tools Needed for Installation. This vehicle has metric fasteners:
- 3/8″ ratchet socket set […]

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
3. Disconnect the mass air sensor electrical connection.
2. Remove the 8mm bolt that retains then engine cover onto the engine then remove the cover from vehicle.
4. Loosen the hose clamp at the throttle body.
5. Loosen the hose clamp at the mass air sensor.
6. Detach […]

[Read more →]

STEP 1: BEFORE YOU BEGIN
WARNING: ALL TRAILTECH FLYWHEELS WILL CHANGE THE PERFORMANCE OF YOUR VEHICLE. It is highly recommended that you spend the time necessary to familiarize yourself with the performance changes, and become comfortable with the way the bike produces power with the new part.

[Read more →]

Preparation for Installation
1. Make sure that there are no metal chips or other debris inside the manifold. Check that all bolts will run freely into any tapped holes.
2. Note that while this manifold makes provision for all vacuum lines and other brackets or parts that attached to the stock manifold, the vacuum ports originally on […]

[Read more →]

You will need a portable crane and/or a friend to lift the motor from the crate and on to the boat. Take your time and be careful. Keep fingers clear of pinch points near the mount and swivel.
Uncrating: Remove the handle and mount it to the side of the engine with three, 3/8″ bolts. Be […]

[Read more →]

SECTION 1: PRE-INSTALLATION PRECAUTIONS:
Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located in your owner’s manual. If you cannot find the radio code, take your car to your local Honda dealer so that they can retrieve the code through […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Disconnect electrical connectors to throttle body & factory intake tube. See Fig#1
3. Using a 10mm socket, remove two bolts holding throttle cable bracket to intake manifold. Retain bolts for later use. See Fig#2
4. Remove throttle cable(s) from throttle body.
5. Using a Phillips screwdriver, loosen hose clamp on factory intake […]

[Read more →]