Automotive Manual PDF

Adapter Installation Location:
The HONASX connects to the 14-pin connector on the back of the factory head unit.
Compatible Radios:
The HONASX is compatible with ‘03-’06 Honda CD changer control head units with 14 pin connector. Note: As vehicle manufacturers continually introduce updated radio models there may be instances where the interface is not compatible. Please contact Technical […]

[Read more →]

Take care to follow the above diagram.
There are two leds located on the PCB, a GREEN and YELLOW. Their purpose is to aid the initial installation. A direction change is indicated with the leds. Ensure the wire pairs of the electric motors are correct (in the same direction) or the mirrors will operate opposite to […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Disconnect electrical connectors to throttle body & factory intake tube. See Fig#1
3. Using a 10mm socket, remove two bolts holding throttle cable bracket to intake manifold. Retain bolts for later use. See Fig#2
4. Remove throttle cable(s) from throttle body.
5. Using a Phillips screwdriver, loosen hose clamp on factory intake […]

[Read more →]

Removal
1) Disconnect negative battery cable and ground strap at transaxle. Disconnect positive battery cable. Remove battery and battery base. Remove drain plug, and drain transaxle fluid (remove fill plug to speed draining). Install drain plug with NEW washer, and tighten plug to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.
2) Disconnect wiring […]

[Read more →]

This document describes car models to which the Super Airflow Converter (Product code: 401-A911/401-A913) is applicable, and ECU terminal arrangement drawings. For the operating method and precautions for the Super Airflow Converter, refer to the Instruction Manual. When installing the Super Airflow Converter, both this document and the Instruction Manual are required. Even if the […]

[Read more →]

Remove the Stock / OEM Instrument Panel
1) Make sure to disconnect the vehicle battery before you begin to remove the instrument panel.
2) Remove the two 5/16” screws which are holding the steering column tight to the base of the dash. This allows the steering column to drop down slightly.
3) Remove the six screws that are […]

[Read more →]

Zone Offroad Products recommends this system be installed by a professional technician. In addition to these instructions, profes-
sional knowledge of disassembly/ reassembly procedures and post installation checks must be known. Minimum tool requirements
include the following: Assorted metric and standard wrenches, hammer, hydraulic floor jack and a set of jack stands. See the “Special
Tools Required” section […]

[Read more →]

Installation Instructions:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Using 10mm socket remove (3) nuts and studs from front side of throttle body. (Ref. “C”)
4. Remove air cleaner mounting stud and bolt from throttle linkage bracket and save.
5. Install (2) linkage extension plates using (2) 5/16 x 3/4” flat head screws. (Ref. “D”)
6. […]

[Read more →]

The RetroGauge™ Mini-Tach is designed for use with a standard ignition coil as factory fitted to 1967 and 1968 Ford Mustangs. For aftermarket ignition systems please read the important application note at the bottom of the page.
INSTALLATION
1. Disconnect the battery negative terminal from the vehicle to completely isolate the electrical system.
2. Remove the instrument cluster […]

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake assembly.
3. Remove (2) bolts & save from linkage bracket. (Ref. C)
4. Remove (4) bolts from the throttle body. (Ref. D)
5. Remove gasket and clean surfaces.

[Read more →]