Automotive Manual PDF

Installation of performance parts requires good mechanical ability and a complete understanding of the entire machine. The instructions we provide are guidelines only and will not thoroughly explain how to set up a racing vehicle. Claims of performance gains, durability, etc. are based on the experience of TEAM Industries and others and do not constitute […]

[Read more →]

FITTING INSTRUCTIONS
Step 1 Remove the original stator & rotor.
Step 2 Fit the new rotor on to the crank shaft locating on to the key (not all models are supplied with a keyway machined into the rotor). Fit the retaining nut but don’t fully tighten if there is no keyway.
Step 3 Position the new stator over […]

[Read more →]

Removal of Factory Intake
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip the six over center clamps, then remove the air cleaner lid.
3. Remove the air injection pump hose from the stock intake tube.
4. Remove the crank case vent hose from the stock intake tube.
5. Loosen the hose clamp at the […]

[Read more →]

Here we are installing Ford Racing C-Springs on an 04 Mustang GT. I’ll be using a 2-post lift for easy explanations and visual clarity, but the same procedure goes for those using a jack and jack stands. Remember, after installation, it is important to get a front wheel alignment. Camber/Caster plates may not be necessary […]

[Read more →]

This install guide is for the FR500 Steering wheel, which I purchased from AmericanMuscle. It is one of the very few racing-style steering wheels that allow for a stock-for-stock swap from the regular steering wheel. You put the horn, airbag, and cruise control switches back in the original location. The FR500 steering wheel features a […]

[Read more →]

Below you will find instructions on how to install your AC Line kit for the Acura Integra DC 94-01 Chassis.
*AC Kit may not be legal for highway use. Hybrid Racing is not responsible for any direct or indirect, actual or incidental expense attributed to the use of any performance parts sold by Hybrid Racing LLC. […]

[Read more →]

The wire colors on my vehicle do not match the colors in your diagram. What do I do?
Unfortunately vehicle manufactures frequently change the color of the wires in their wiring harnesses. The wire that we need locate is the factory door-ajar signal located inside each door. You can find this circuit by removing the door […]

[Read more →]

This workshop manual contains repair instructions for the 2001, 2002 and 2003 engines. The instructions concerning overhauling describe the most suitable working method using the special tools listed under the heading “Special tools” . Both the engine designation and its serial number must be clearly stated in all correspondence concerning the engine and when ordering […]

[Read more →]

Under racing conditions, the engine in the BMW E36 M3 may “starve” for fuel when the amount of gasoline in its tanks falls below a certain level. This Application Guide details the installation of twin fuel pumps on a 1995 M3 Lightweight to alleviate this problem. The E36 3 series1 uses a molded one-piece plastic […]

[Read more →]