Automotive Manual PDF

RSS Feed

The Resources for Automotive

1998–2000 Ford Contour and Mercury Mystique Front Coil Springs Breaking

August 4th, 2010 · No Comments

PROBLEM: Front Coil Springs Breaking • Front coil springs for the Ford Contour and the Mercury Mystique from 1998 to 2000 could potentially fracture due to corrosion and fatigue. Tires can be punctured by coming in contact with a broken spring.
SOLUTION: MOOG® Coil Springs 80160 and 80162 • MOOG offers a replacement, constant rate coil spring that is designed to provide more (more…)

[Read more →]

01-03 Ford Ranger/SportTrac 4.0L SOHC PowerAid Throttle Body Spacer

July 12th, 2009 · No Comments

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake cover.
3. Remove air intake hose assembly.
4. Remove (4) bolts from the throttle body.
5. Remove throttle linkage bracket and save screws. (Ref. “B” & “C”)
(more…)

[Read more →]

2004 Ford Econoline – 6.0L Diesel Engine Intelligent Lift Interlock System (ILIS501-DC) – Installation Instructions

May 22nd, 2009 · No Comments

To aid in installation, first gain access to the connection points. Remove the lower dash panel below the steering column. Also, gain access to the lift power switch and the lift door switch circuits. These are usually accessible in the front control panel. It is not necessary to cut any Ford wires during the installation of the ILIS wire harness.
(more…)

[Read more →]

2003-07 Ford Power-Stroke V8 6.0L

March 27th, 2009 · No Comments

The 4” straight hose is pressed over the turbo inlet until its butted up against the inlet. Use two power bands to fasten the hose to the turbo inlet, tighten the clamp on the turbo inlet side for now. The 19mm hose is pressed over the 90 degree hard pipe (A) The 19mm hose is now installed (B).
(more…)

[Read more →]

Ford 6.0L Turbo Air Guide (TAG) install: 2003-2004

March 16th, 2009 · No Comments

Remove the flexible rubber hose from the air filter to the hard plastic intake tube which connects to the turbo charger. Remove the bolts securing the hard plastic intake tube and associated tubing and clamp.

The picture to the left shows the orientation of the TAG to be inserted into the hard plastic intake tube.
(more…)

[Read more →]

Intercooled Supercharger System for 6.0L V8

September 13th, 2008 · No Comments

You have made an important decision and we commend your choice. We’re confident you’ll be happy with the ease of installation and the outright performance improvement of this bolt-on Magna Charger kit.

Our parent company, Magnuson Products, is the exclusive aftermarket supplier for all Eaton superchargers; therefore our products are built to OEM standards for function and durability. Your kit has been thoroughly tested and carries California Air Resources Board EO # (N/A at this time)
(more…)

[Read more →]