1. Place the motorcycle on the centerstand.
2. Remove the left side cover (painted) to expose the battery. Remove the left plastic engine cover (chrome). Remove the lower center fairing cowl or spoiler; there are 2 pull pin rivets and 6 allen screws holding this panel in place. Drop the panel down and slide it out to the right or left.
3. Horns and Mounting Bracket: Attach the large “L” shaped bracket with the split clamp to the engine guards as shown in photo #1. NOTE: Make the screws snug only! Install the horn set onto the “L” bracket using the 2 allen screws provided, tighten securely. Align the horn set to be level and to have clearance between the fairing as shown in photo #2, tighten securely.
(more…)
Honda GL1800 Front Mount Air Horn Installation Instructions
November 14th, 2009 · No Comments
1975-1981 Harley-Davidson Golf Cars IMC Carburetor Retrofit Kit Installation
October 19th, 2009 · No Comments
STEP I ASSEMBLY INSTRUCTIONS – Fuel Pump / Carburetor / Manifold
A) Install fuel pump on carburetor, using shortest fuel line hose (1 ū” long) and two small diameter clamps. Ensure that you connect the correct nipple from the fuel pump to the carburetor. (Refer to Fig. 3)
B) Install carburetor and fuel pump assembly on the intake manifold, along with gaskets, insulation block, lock washers and nuts supplied in kit. (Refer to Fig. 2) Tighten nuts to 8 – 12 foot lbs. torque.
C) Attach one end of 7″ fuel line to the pulse tube on the intake manifold. Slide two small diameter clamps over the fuel line and then attach the other end of the line to the crankcase fitting on fuel pump. (Refer to Fig 3.) Position clamps at each end of hose and tighten securely. Proceed to STEP II.
(more…)
