Automotive Manual PDF

Installation
1. Slide four 5/16” dia x 1-1/4” wide U-bolts (C1) over the underside frame of the ATV. If unsure of their location, position the plow mount (A1) against the underside of the ATV, just in front of the skid pan, and find the approximate location of where the U-bolts go.
2. Once the U-bolts (C1) are in place, position the plow mount (A1) under the vehicle, and slide the legs of the U-bolts through the eight holes in the plow mount. Work on one U-bolt leg at a time, as a threaded end is exposed, terminate the U-bolt leg with a 5/16” dia flat washer (C2) and 5/16” dia nylock nut (C3). Continue until each U-bolt has a washer and nut on the end of it.
NOTE: Do not tighten the bolt and nut completely. You will do this in the next step
(more…)

[Read more →]

This transbrake has been thoroughly tested before being packed and shipped. Proper operation depends on following a few basic instructions. As you may know, the AODE/4R70W transmissions are computer controlled and must retain all wiring connections inside and outside the transmission. The following photos will help with the installation and operation of this transbrake.
(more…)

[Read more →]

Thank you for purchasing Granatelli Signature Series cold air induction system. Like all Granatelli Motor Sports products, great pride and precision craftsmanship went into making these parts.
1. Disconnect your negative battery cable
2. Sliding the red safety tab backward, unplug your factory mass airflow sensor. Depress the black and slide the connector from the sensor itself.
3. Remove the breather tube from both the stock air intake and the valve cover; you will no longer be using this piece.
4. Remove the 10mm bolt holding the stock air box to the inner fender. Be sure to keep track of this bolt, you will be reusing it later (step 7).
(more…)

[Read more →]