Automotive Manual PDF

How to use the Xcalibrator 2:
Plug the OBD-II connector into the port under the dash of the vehicle you wish to program. Some vehicles may have a panel that needs to be removed to access it. With the key off, use the up and down arrows to navigate through the main menu.
(more…)

[Read more →]

Before beginning installation, familiarize your-self with the installation instructions and the ultrasonic parking assist system components.
To ensure your safety:
A) Make sure your vehicle is in “PARK”.
B) Apply the emergency brake.
C) Read this manual before starting.

CAUTION: It is advisable to disconnect the negative battery cable for 3 minutes before beginning installation, to avoid unintended air bag deployment. Note and record any anti-theft radio codes prior to disconnecting.
(more…)

[Read more →]

Locate the vacuum – There is a vacuum point on the inlet tract, as shown below left. Remove the screw and replace with the M5 Brass Spigot from the Scottoiler kit, using some RTV Silicon Sealant on the threads to ensure an airtight seal. Then press the Damper Elbow, part number 4, onto the spigot.

The RMV can be mounted on the frame as indicated by the arrows in the third picture. The more vertical the RMV the better and remember to avoid exhaust and engine components. For other fitting options, see our easy step installation guide ‘RMV Positions, General’.

The Dispenser Assembly, shown bottom left, is routed along the underside of the Swingarm using Dispenser Mounting Sleeves, Cable Ties & Glue. Note: an epoxy resin (eg. Araldite) is req’d to bond the sleeves to the Swingarm. For further information see our easy step installation guide - ‘Dispenser Assemblies, General’.

Once fitted, fill and prime the system and set the adjuster knob to ‘prime’. Start the engine and turn the adjuster knob until a flow of between 1 and 2 drops per minute is achieved. Check the condition of your chain after a ride, and then adjust as required. The nib should feed the sprocket between the 6 & 7 o’clock positions, with the cut face facing outwards. The Dual Injector (sold separately) is shown below.

Get pdf Scottoiler: Ducati ST4s Installation

[Read more →]

Engine, removing and installing
Note:
All cable ties opened or cut during engine removal must be reinstalled at the same locations.
Remove engine without transmission toward the front.
Drained coolant must be stored in a clean container for disposal or reuse.
Always replace seals and gaskets.
Do not open coolant circulation system.
(more…)

[Read more →]

Removing steering column switch
Driver’s side airbag unit and steering wheel removed.
- Pull out steering column and tilt downward as far as it will go.
- Remove screws -1-(2x). Tightening torque: 2.8 Nm (25.2 in lb)
- Remove grip - 2-.
- Remove two Phillips-head screws -arrows-. Tightening torque: 0.6 Nm (5.4 in lb)
- Remove upper steering column switch trim -1-.
When installing, insert upper section into hooks on lower section, swivel downward and secure with screws
(more…)

[Read more →]