These instructions explain the procedure required to mount either the Windjammer IV or Vindicator II fairing to your motorcycle. We urge you to follow the preparation and assembly sequence from start to finish. This will benefit you directly in several ways:
1) You will be assured the fairing is properly installed and is immediately ready for operation.
2) You will minimize unnecessary confusion, moaning and scraped knuckles.
3) You will protect your investment by doing it right, and
4) With the confidence that nothing has been overlooked, you won’t have to waste time backtracking to correct mistakes. That’s time you could spend riding.
(more…)
1975-79 Honda GL 1000 Windjammer IV Vindicator II Mounting Instructions
November 16th, 2009 · No Comments
Honda 750 Shadow Aero Models Hypercharger Kit Installation
October 29th, 2009 · No Comments
A factory service manual is necessary to perform this installation. Do not attempt to perform this installation if you are not confident in your ability to perform all steps in the procedure, including precise drilling and tapping; consult a trained technician.
Procedure remove the stock aIr cleaner and carburetor
steP 1 Remove the seat, dash panel, and fuel tank; consult your factory service manual for specific instructions on performing this procedure.
steP 2 Remove the air cleaner assembly. Save the clamp securing the rubber manifold to the carburetor, it will be reused later. See PIC.1.
steP 3 Remove the carburetor for re-jetting; consult your factory service manual for specific instructions on removing the carburetor. Prepare the carburetor for re-jetting by removing the top cover, see PIC.2.
(more…)
Hauler Rack II - Universal Truck Series Racks Assembly Instructions
September 30th, 2009 · No Comments
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
(more…)
