All left / right descriptions are from the point of view of the rider when seated on the bike in the riding position.
Note: the condenser upgrade cable supplied will have a black cover to make it inconspicuous enough for a concours show bike. The example shown has a red cover to highlight the correct location and routing.
1. Place the bike on the center stand.
2. Remove the left side cover.
3. Loosen the rear engine mounting bolt. This is a long bolt that passes through both rear engine hangers. If mounted correctly, the nut, washer and lock washer should be on the right side of the bike. Yours may be reversed.
(more…)
Honda GL1000 Condenser Ground Upgrade Mounting Instructions
November 10th, 2009 · No Comments
Dodge Ram 2002-2007 AMP Installation
September 8th, 2008 · No Comments
AMP RESEARCH BEDSTEP™ – DODGE RAM
Locate rear bumper attachment point on driver side. Remove bumper fasteners. Install upper mount onto linkage as shown and torque bolts to 33 ft-lbs / 44 Nm. Slide upper mount over factory studs, install fasteners and torque to 59 ft-lbs / 80 Nm. Install step pad assembly onto linkage assembly with two socket cap screws. Adjust step pad position side to side. Allow for foot access. Torque allen head bolts to 10 ft-lbs / 13.5 Nm.
(more…)
