Tools Needed: 10, 12, 14 sockets and wrenches. You will also need a Oxygen Sensor removal tool or 22mm wrench or socket to remove the stock Oxygen sensors from the catalytic converter and install them in the new Jackson Racing header. Most of these tools are available at your local hardware or auto parts store.
IF YOU ARE NOT A COMPETENT MECHANIC, DO NOT ATTEMPT THIS INSTALLATION! ALLOW AT LEAST ONE HOUR FOR THE EXHAUST SYSTEM TO COOLBEFORE DOING ANY EXHAUST SYSTEM INSTALLATION WORK.
READ THESE INSTRUCTIONS THOROUGHLY! Follow the instruction STEP-BY-STEP, and your installation will be trouble free. If in doubt, CALL!
(more…)
[Read more →]
1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps. Handle the LED array by the stainless steel bracket, not by the LEDs or the supporting circuitry.
2. Remove taillight lens and gasket.
3. Remove taillight bulb.
4. Remove the bulb connector from the back side of the taillight. Cut the two wires close to this connector.
5. Install the provided wire guide into the bulb hole.
6. Route the supplied electrical harness through wire guide to the area where connections will be made. Note that the ground connection (green wire) is made through the LED array’s stainless steel bracket.
(more…)
[Read more →]
Thank you for the purchase of your new Hummer H2 spare tire cover. Please inspect your package contents before beginning installation. Included should be a molded faceplate and stainless steel retaining ring with locking mechanism. The stainless steel ring is covered with a protective vinyl cover that should not be removed until installation is completed.
(more…)
[Read more →]
