Removal
1) Disconnect negative battery cable and ground strap at transaxle. Disconnect positive battery cable. Remove battery and battery base. Remove drain plug, and drain transaxle fluid (remove fill plug to speed draining). Install drain plug with NEW washer, and tighten plug to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.
2) Disconnect wiring for starter motor, transaxle lock-up control solenoid and shift control solenoid. Remove starter. Disconnect mainshaft and countershaft speed sensor connectors. Remove complete air cleaner case assembly. Disconnect and remove throttle control cable at transaxle bracket.
(more…)
1993 Honda Prelude Transmission Removal & Installation
November 6th, 2009 · No Comments
Ford 2″ Coil Spring Spacer Kit with Stud Extenders Installation Instructions
April 26th, 2009 · No Comments
If your vehicle has factory 2 ½” studs holding the coil spring onto the axle assembly, you will not need to use the stud extensions.
Step:
1. Read complete instructions and check Bill of Materials before beginning.
2. Raise the front of the vehicle and support the frame so that the front tires just touch the ground and remove the front tires.
3. Remove the lower shock bolts and the sway bar end link attaching points.
(more…)
